How to install

To install your AVX Labs Magnetic Bracket, listen to the following instructions:

__________________________________________________
STEP 1: PLACE MAGNETS INCLUDED IN PACKAGE IN THE MAGNET SLOTS ON THE BRACKET.⬇️

STEP 2: Take off your license plate.

STEP 3: Use your original 2 license plate screws to screw in the new magnetic bracket. (After installed, the bracket should be fully seated horizontally with both magnets on. On rare occasions, if your screwhead is smaller than the hole of the magnet and doesn't properly secure it, you may have to use the smallest washer possible. But, this is extremely uncommon)

STEP 4: Wipe off the dust and dirt of the front of your license plate or the adhesive will not stick correctly.

STEP 5: Peel the red adhesive backing off ONE license plate clamp. Place it over the screw hole on the top left or top right of your license plate, ensuring it is centered. Make sure the metal rings are on the back of the license plate (SHOULD ONLY SEE BLACK ON THE FRONT OF THE LICENSE PLATE, AND THE METAL RINGS ON THE BACK.) Repeat with the second clamp. Before pressing them down firmly, make small adjustments to ensure each clamp is perfectly aligned and fully seated over the magnets on the bracket.

STEP 6: Each time you attach your license plate, you should feel and hear the metal rings snap securely onto the magnets. Ensure the metal rings are fully seated over the screw heads on the bracket before driving.