To install your AVX Labs Magnetic Bracket, listen to the following instructions:
IF YOU CANT UNDERSTAND BELOW, DM US ON TIKTOK OR EMAIL. WE WILL SEND YOU A VIDEO.
__________________________________________________
STEP 1: PLACE MAGNETS INCLUDED IN PACKAGE IN THE MAGNET SLOTS ON THE BRACKET.⬇️
STEP 2: Take off your license plate.
STEP 3: Use your original 2 license plate screws to secure the new magnetic bracket.
IMPORTANT: Your screw heads must be 9.7–10.1 mm in diameter to properly secure the magnets. If your original screw heads are smaller than the magnet openings, they may not properly secure the bracket. This is uncommon, but if needed, replacement screws are available at most local hardware or automotive stores for under $0.20.
DO NOT DRIVE WITH THE BRACKET INSTALLED IF THE SCREW HEADS DO NOT PROPERLY SECURE THE MAGNETS.
STEP 4: Screw the 2 clamps with metal rings on them horizontally on the backside of the license plate through the normal license plate holes. Use the washers included if you aren't using a plate frame, if you are using a plate frame, no washers needed. Keep the washers included handy incase you decide to take off your plate frame.
STEP 5: You're done! Everything is ready.
STEP 6: Each time you attach your license plate, you should feel and hear the metal rings snap securely onto the magnets. Ensure the metal rings are fully seated over the screw heads on the bracket before driving.